Released:01/2014
E-mail: service@amfreece.cz; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
E - STANDARD MACHINE ADJUSTMENT
Warning:
- before making any adjustments, turn the main power switch off
- careless adjustment can cause damage to electronic and mechanical parts
Caution:
- always maintain good safety standards
- where possible, remove the sewing needle before making mechanical adjustments
1. STANDARD BUTTONHOLE SHAPES SET BY THE MANUFACTURER
There are two types of zero buttonhole preset in the program, one type with eye and y bar for AF, CT, LTT
modicationsandsecondtypeofroundeyeforRDEmodicationaccordingtothefollowingoverview.Ispossibleto
use the universal program, which allows, after clamp plates and necessary parts replacement, programming of all
advertised buttonhole types, by changing zero buttonhole. Rear thoroughly the section “D” for adjustment - machine
function control..
Warning: Check every time the number of program is changed, if the needed buttonhole shape is selected properly.
To Next Page
Loading...
