Released:01/2014
E-mail: service@amfreece.cz; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
E - STANDARD MACHINE ADJUSTMENT
18. PRACTICAL RECOMMENDATION FOR SEWING ROUND EYELET
18.1. Pull out gimp thread from guide with spring (gimp thread is gotten out from thread plate):
18.2. Parameter for electronic adjustment of trimmed threads tails must be adjusted for 26 mm:
18.3. Gimp thread draw-off guide must be adjusted in backward direction - to
direction:
18.4. Because sewing round eyelet generated more waste of thread, machine must be cleaned more often.
Security
screw
To Next Page
Loading...
