5-4 Preset Menu System Operations
5-10 PN: 10580-00252 Rev. K Site Master User Guide
5-4 Preset Menu
Key Sequence: Shift, Preset (1)
5-5 Self Test
At power on, the Site Master runs through a series of quick checks to ensure that the system
is functioning properly. The System self test runs a series of tests that are related to the
instrument hardware. The Application self test runs a series of tests related to the
instrument hardware that is used in the current operating mode.
If the Site Master is within the specified operating range with a charged battery and the self
test fails, contact your Anritsu Service Center at http://www.anritsu.com/contact-us.
To initiate a self test when the system is already powered up:
1. Press the Shift key, followed by the System (8) key.
2. Press the Self Test submenu key. The Self Test results are displayed.
3. Press Esc to close the Self Test results dialog.
Preset: This key resets the instrument to the default starting conditions.
Save Setup: Opens the Save dialog box (see Figure 4-1 on page 4-2) to
name and save the current operating settings, allowing them to be recalled
later to return the instrument to the state it was in at the time the setup was
saved.
The saved setup can be named using the touch screen keyboard. Use the
Caps key to select an uppercase letter. Use the Left/Right directional
arrows to move the cursor position. Press Enter to save the setup.
Note: Set the File type as Setup. See “Save Menu” on page 4-11 for details.
Recall Setup: This key allows the selection and recall of a previously
stored instrument setup using the “Recall Menu” on page 4-14. Use the
rotary knob, the Up/Down arrow keys, or the touch screen to highlight the
saved setup, and press Enter. All current instrument settings are replaced
by the stored setup information.
Figure 5-12. Preset Menu
Recall
Setup
Preset
Save
Setup
Preset
To Next Page
Loading...
