3-4 W-CDMA/HSPA+ RF Measurements W-CDMA/HSPA+ Signal Analyzer
3-10 PN: 10580-00234 Rev. T 3GPP MG
3. Press the RF Measurements submenu key.
4. Press the ACLR submenu key to activate the ACLR measurement.
5. Press the ACLR submenu key again and select one main channel and two adjacent
channels (Figure 3-3).
Note
The ACLR measurement uses the filtered channel power to determine the ACLR
values and it is listed as filtered on the display. In all other screens the unfiltered
channel power is displayed as channel power.
Note
Using the Band Spectrum cursor, select the required channel and press the ACLR
submenu key. The measurement will be displayed.
Figure 3-3. ACLR Measurement
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
