2-4 CDMA RF Measurement Setup CDMA Signal Analyzer
2-6 PN: 10580-00235 Rev. D 3GPP2 MG
ACPR Setup
Adjacent Channel Power Ratio (ACPR) is defined as the ratio of the amount of leakage power
in an adjacent channel to the total transmitted power in the main channel and is displayed in
table format under the bar graph.
From the Measurement menu, use the following procedure for ACPR:
1. Press the RF Measurement submenu key.
2. Press the ACPR submenu key to activate the ACPR measurement (Figure 2-5). The red
dot on the submenu key indicates that it is selected.
3. Press the ACPR submenu key again to specify the Number of Carriers in a multi-carrier
configuration and to specify Carrier BW.
Figure 2-5. RF Measurement, ACPR
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
