2-5 CDMA Demodulator Measurements Setup CDMA Signal Analyzer
2-8 PN: 10580-00235 Rev. D 3GPP2 MG
CDP Setup
The CDP screen displays 64 Walsh Codes or 128 Walsh Codes. Pilot, Sync, Paging, and Quick
Paging codes are displayed in a control channel table for easy viewing. Pilot power, channel
power, Rho, channel carrier feedthrough, RMS phase error, Frequency Error, and Noise Floor
measurements are displayed as numerical values.
From the Demodulator submenu, use the following procedure for CDP:
1. Press the CDP submenu key to display the Code Domain Power menus. This may
require pressing the CDP submenu key a second time (Figure 2-6).
2. Press the Zoom submenu key to activate zoom for 16, 32, or 64 codes.
3. Press the Zoom Start Index submenu key and enter the desired location manually.
4. Press CDP Units to select either Relative power (in dB) or Absolute power (in dBm).
Figure 2-6. Demodulator, CDP Setup
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
