AOR AR-DV10 - Page 13

11
2
[VFO]
Operation mode
[VFO]： VFO
[ MEM] ： Memory channel readout
[SCN]： Scan
[SER]： Search
FM15 Demodulation mode and IF bandwidth in kHz or Hz.
FM100, FM30, FM15, FM6 (kHz)
AM15, AM8, AM5.5, AM3.8 (kHz)
USB2.6, USB1.8, LSB2.6, LSB1.8 (kHz)
CW500, CW200 (Hz)
IF bandwidths for digital modes: FM30, FM15, FM6 (kHz)
[D]
Digital demodulation is activated.
DSTR Digital mode which has been set or which has been
automatically detected by the receiver.
DSTR: D-STAR
YAES: YAESU (C4FM)
DMR: DMR (Tier 1 / Tier 2 / MOTOTRBO)
D-CR: Japanese D-CR & NXDN (6.25k)
dPMR: dPMR (446 Tier 1)
ALIN: ALINCO (EJ47U)
P-25: APCO25 (Phase 1)
T-DM: TETRA (Direct mode, mobile to mobile)
[Au]
Auto-detection of digital modes is activated. (Except Tetra)
20k Frequency step in kHz.
Step-adjust value (when activated) is shown in section 5.
3
VFO-A XXXX.XXX XX
VFO-B XXXX.XXX XX
-------------------
00-00 XXXX.XXX XX
BANK.T (bank title)
CH.T (channel title)
00 XXXX.XXX XX
BANK.T (bank title)
Receive frequency (In MHz over 3MHz and in kHz below
3MHz. The VFO of the upper line is the one currently
received.
----------------------
For memory channel readout and scan modes, the bank and
channel numbers are displayed on the upper side. The bank
and channel titles are on the lower side.
For search mode, the bank number is displayed on the upper
side. The bank title is on the lower side.
Memory channel readout mode Search mode
UPPER SIDE→
LOWER SIDE→