POS MV V4 User Guide
Installation
Copyright © Applanix Corporation, 2009
2-54
(POS MV V4-1) Arrange a clean, stable electrical supply at a
nominal voltage
24 Vdc at 2.5 A (voltage range - 20 Vdc to
34 Vdc) for the PCS. If possible, supply electrical power to the
PCS from an uninterruptible power supply.
4. Cable Runs
Install all cables carefully so that they do not present a hazard.
Avoid applying sharp bends or other mechanical stresses to the
cables when you install them. Do not run cables where they may
bend or twist after installation. Use cable clips to secure the
cables at regular intervals along their length.
If you need to extend any cables, use approved cables and
connectors of the highest quality. Refer to Applanix for advice,
see
Technical Support and Service on page A-1 for procedures.
To Next Page
