Applanix POS MV V4 - Controller Software

POS MV V4 User Guide
Introduction
Copyright © Applanix Corporation, 2009
1-20
Controller Software
You can use the MV-POSView Controller program to configure POS MV; the
controller ships with the POS MV system. For subsequent operation of the
POS MV you can use the controller program or you can configure the system
to start operating automatically with no further need for operator control. A
brief description of the AutoStart feature is located on page
1-17.
Refer to the
Software Installation description on page D-1 for instructions to
install the MV-POSView Controller program on your PC. Refer to the
System
Configuration description on page
4-1 and the System Operation description
on page
5-1 for instructions on how to use the controller program.