Applanix POS MV V4 - MV-Posview Controller Program

POS MV V4 User Guide
System Configuration
Copyright © Applanix Corporation, 2009
4-6
Use the MV-POSView Controller program to enter this information. Save
these parameters to NVM if you require the system to use the same
configuration after each power-on sequence. POS MV retrieves these details
from memory after a power-up or after a reset command. Refer to the
POS
MV Configuration description on page
4-11 for instructions on configuring the
system with installation parameters using the MV-POSView Controller
program.
MV-POSView Controller Program
Refer to the Software Installation appendix, page D-1, for instructions on
installing the MV-POSView Controller program on a PC.
The following assumes that the controlling PC has a suitable version of
windows installed and that you are familiar with its operation. If necessary,
refer to the manuals supplied with the controlling PC for instructions on how to
use your version of windows.
• Connect the PCS and the controlling PC to the 10/100BaseT Ethernet
LAN
• Power-on the PCS and the controlling PC, and start Microsoft
Windows™; from windows, launch the MV-POSView Controller
program
MV-POSView connects automatically and starts to display information
broadcast by the PCS over the Ethernet if you have installed and configured
the PCS, the controlling PC and the MV-POSView Controller correctly.
The controller program can operate in either of two modes:
• Monitor mode - the MV-POSView Controller program displays all PCS
data that is broadcast over the Ethernet, however, changes to any of