POS MV V4 User Guide
System Operation
Copyright © Applanix Corporation, 2009
5-29
configuration, the heave filter parameters and the data groups that you
selected for output on the display, and real-time and logging data ports. Once
the system is initialized, it will begin to output data across the enabled ports.
Refer to the
Data Logging instructions page 5-14 for a full description of the
data logging facilities available for the POS MV.
When the system operates in stand-alone mode, the front panel lights on the
PCS continue to provide an indication of the system status as described in the
Power-On instructions on page 4-1.
In stand-alone mode, whichever outputs you enabled and saved to the NVM
will be available from the PCS. Data output will begin when the SYS light, on
the PCS front panel, begins to flash green.
The PCS will begin to broadcast Ethernet data as soon as the POS MV is
powered-on. The Ethernet messages contain only POS MV status and time
until the SYS light begins to flash green, at which time the PCS will start to
broadcast all the selected output groups.
To Next Page
