Copyright © Applanix Corporation, 2009
Liability and Safety Information
Important: All cables connected to the POS MV V4 and POS MV
V4-1 equipment shall be constructed of (in order of preference):
a) halogen free, b) low smoke and c) high temperature materials.
Ethernet Cable - Applanix supplies a suitable Ethernet cable. However, if
supplied by the customer the cable shall incorporate a braid shield, having at
least 90% coverage that has a 360 degree termination at both connectors,
and be rated as CAT5 or better. The RJ45 connectors used in the cable shall
also be shielded.
Serial Cables - Applanix supplies suitable COM port serial cables, each are
about 3.6 m (12.0 ft) in length. If the cables are supplied by the customer
each cable shall incorporate a braid shield, having at least 90% coverage that
has a 360 degree termination at the backshells of both connectors.
Power Cord - Applanix ships a specially constructed power cord with its
POS MV V4 ac products and is detailed in
Appendix E. Otherwise, the
customer is responsible for supplying and using a compliant power cord.
Ensure that the destination country electrical codes are adhered to. Applanix
recommends an ac power cord not exceeding 2 m (6 ½ ft) in length and that
can safely handle a maximum of 10 A.
Regulatory Information
Caution: Do not make mechanical or electrical modifications to the
POS MV V4 or the POS MV V4-1 systems or any of their
components. Changes or modifications not expressly approved by
Applanix could void the compliance and negate your authority to
operate the product.
Certification was achieved using the following original or
replacement equipment supplied by Applanix: GNSS antennas,
GNSS antenna cables, Ethernet cable, IMU, IMU cable, RS-232
serial cables and power cord.
To Next Page
Loading...
