TD 92477EN
8 April 2016 / Ver. M
User Manual
Ascom d62 DECT Handset
13
2.5 Alphanumeric Keys
006
. , ? ! - ‘ ” 1
a b c à â ä æ ç 2
d e f é è 3
j k l 5
m n o ñ ò ö ø 6
t u v ù ü 8
#
g h i î 4
b
p q r s β 7
w x y z 9
Space + * 0
Figure 5. Available characters.
NOTE: Depending on the selected menu language and character se
tting in the IMS3/Unite
CM, other characters can be available. This means that the character order can differ from
the figure above.
In standby mode, and number in
put mode
• A short press on a key enter the digits “0” - “9” and the characters * and #.
• Enter a pause in number input mode by a long press
on the # -key. A pause is indicated
by a "P" in the display.
• A long press on the * - key changes the tone sender on.
Tone sender on is indicated by a "T" in the display.
In text input mode
• A short press on a key 0-9, displays the first availab
le character on that specific key. The
marked character is selected after a timeout, or when another key is pressed.
• To change to upper or lower case, press the * -key before e
ntering the character.
The *-key can also be used to display only the digits.
• To add space in the text, make a short press on key 0.
• The first character entered in a message, or when ad
ding or editing a name in the
Contacts menu, is an upper level character followed by lower level characters, unless the
* -key is pressed before entering the character. To switch between Abc, ABC, abc, and
123 the *-key is pressed.
• A long press on the #-key displays special characters.
To Next Page
Loading...
Need help?
General
