TD 92477EN
8 April 2016 / Ver. M
User Manual
Ascom d62 DECT Handset
12
2.4.7 Soft Keys
Call
List
Soft keys
003
Figure 4. Soft Keys.
The three Soft keys are located just beneath the display and the functions of each Soft key
is ind
icated by text in the display just above the keys.
In idle mode, the Soft keys can be used for spec
ific functions defined by the user of the
handset.
2.4.8 Hot Keys
Any key "0", "2" - "9" can be set to a Hot Key. A
long press on any of these numbers in stand
by mode are by default a shortcut to the Call contact list. The list is in alphabetic order, and
depending on which key that is pressed is dependent on where in the list the contact
appears.
A Hot Key can be programmed to give access to frequently used functions such as dialling a
spe
cific handset number, a shortcut on the menu, or sending an SMS.
2.4.9 Multifunction Button
Note: This feat
ure is applicable for d62 Talker and d62 Messenger only.
This button can be used as a shortcut to function
s; long or double press modes. It is by
default not used, but can be defined by the user of the handset. If the button is defined, it
can be used in standby mode only.
2.4.10 Volume Button
The two buttons placed on the upper left side of the ha
ndset are used for increasing/
decreasing the earpiece, headset, and the loudspeaker volume.
To Next Page
Loading...
Need help?
General
