TD 92477EN
8 April 2016 / Ver. M
User Manual
Ascom d62 DECT Handset
45
7 Alarm Operation
NOTE: The following system dependent features are applicable for d62 Protector only, see
the Configuration Manual for the Ascom d62 DECT Handset.
IMPORTANT: If a shared phone is used, it must be logged in to the system to be able to
send alarm. See
4.2 Log a Shared Phone On and Off on page 22.
7.1 Push-button Alarm
Press the red alarm button twice within two seconds to activate the alarm. An information
text is displayed, default “Personal Alarm” is displayed. The alarm is sent to the alarm
central that distributes it further. After that the handset returns to stand-by mode. Note
that you can always trigger the alarm when you are speaking, editing your settings, or while
the handset is locked.
7.2 Acoustic Location Signal
An alarm can be followed by an Acoustic Location Signal (ALS). The ALS is a signal from the
handset that sounds for a predefined period of time. The signal is silenced by pressing the
Mute button on the handset.
7.3 Test Alarm
Press and hold the red alarm button until the information text is displayed, default “Test
Alarm” is displayed.
7.4 Alarm with Location Information
Information about the handset’s location can be sent along with an alarm. The location can
be added as follows;
• Manually added by the user (see 7.4.1Alarm with Data) or,
• An approximately location given by the closest Base Station (see the Configuration
Manua for the, Ascom d62 DECT Handset) or,
• A precise location given by DECT location devices (see the Configuration Manual for the
Ascom d62 DECT Handset)
7.4.1 Alarm with Data
The data must manually be defined and stored by the user. To use the function, one Soft/
Hot key/Navigation key in the handset must be defined as a shortcut to the menu “Edit
alarm data, see
8.3 Shortcuts on page 58. The stored data is added to all types of alarm at
transmission.
To Next Page
Loading...
Need help?
General
