TD 92477EN
8 April 2016 / Ver. M
User Manual
Ascom d62 DECT Handset
22
4 Basic Operation
4.1 Switch the Handset On and Off
Switch on the Handset
Press and hold
. When pressing , the handset vibrates and the display lights up.
Switch off the Handset
Prerequisite: The handset is in idle mode:
Tip: While in a m
enu, press to return to idle mode. If the handset is a shared phone, it
must first be logged out to be able to switch off the handset. See 4.2Log a Shared Phone On
and Off. A user can be prevented from switching off the handset by enabling the parameter
Prevent switch off in
PDM.
1Press and hold
.
2 A dialog window "Switch off?"
is displayed. Confirm by pressing "Yes".
NOTE: If a handset restriction is enabled, it may not be poss
ible to switch off the handset.
See the handset’s Configuration Manual.
4.2 Log a Shared Phone On and Off
NOTE: Shared phone is a license dependent feature and is applicable for IP-DECT systems
only. See the Configuration Manual for the Ascom d62 DECT Handset.
The feature shared phone allows more than one user to use a handset. When a handset is
configured
to be a shared phone, it can be used by any shared phone user in the system. The
message and call lists are deleted when a user logs off a handset.
NOTE: If configured in the PDM/Device Manager, an eme
rgency call can be made from a
handset that is logged off. See the Configuration Manual, Ascom d62 DECT Handset.
Log on a Handset
Prerequisite, the handset is switched on. See 4.1Switch the Handset On and Off for more
information.
1 A dialog window "Login?" is displaye
d. Press the soft key "Yes".
2 Enter User ID and password.
3Press "Login".
NOTE: The user will be automati
cally logged out from a previously used handset.
To Next Page
Loading...
Need help?
General
