ASCOM D62 User Manual

TD 92477EN
8 April 2016 / Ver. M
User Manual
Ascom d62 DECT Handset
41
read message, in the message inbox (left in the figure). The messages are indicated by a
gradient colour bar behind the envelopes. In addition, a gradient colour bar is shown below
the envelop when reading a coloured message (right in the figure).
12:34
Call Reject
2009-01-01 12:00
Patient ready for transport.
From: X-ray
To: B/12/3
Help
12:34
View Back
More
Patient ready...
2009-01-01
Patient ready...
2009-01-01
Inbox
008
Figure 7. Shows an example of a coloured message.
To enable coloured messaging, see th
e corresponding manual for the application used. In
addition, coloured labels can be mapped to message beep codes. See the Installation and
Operation Manual for IMS3/Unite CM.
6.10 Decline a Call with a Predefined Message
A call may be declined with a predefined message by the called party provided that both
parties are connected via an IP-DECT system. To decline a call with a predefined message
when the handset rings, perform the following steps:
1 In response to the "Reply with a message tem
plate?" prompt, press the "Yes" soft
key to send a message to the caller. A list of predefined messages is displayed in the
"Templates" menu.
2 Select, and if required, edit the message as described in The Templates Menu on
page
37.
3 Click the soft key "Send". The calling party num
ber is displayed in the handset
display.
4 Click the soft key "Send". A "Message se
nt" confirmation is displayed and the
message is sent to the caller.
6.11 Answering a Text Message with a Predefined Message
To respond to an incoming text message with a predefined message, perform the following
steps:
1 Press the soft key "Reply"
2 Press the "More" soft key. The "Tem
plates" option is displayed.
3 Press the soft key "Select". A list of predefined message
templates is displayed.
4 Navigate to the required message template and press the "Select" soft key. If
required
, edit the message as described in The Templates Menu on
page 37.
5 Press the soft key "Send". The message sender
’s number is displayed in the handset
display.
6 Press the soft key "Send". A "Message sent" confirmation is displayed a
nd the
message is sent to the caller.

ASCOM D62 Specifications

General

Brand	ASCOM
Model	D62
Category	Handsets
Language	English