ASCOM D62 User Manual

TD 92477EN
8 April 2016 / Ver. M
User Manual
Ascom d62 DECT Handset
37
The Templates Menu
To access a template and use it in one of the ways described above, pe
rform the following
steps:
1 Open the "Templates" menu as described in t
he context in which the template is
being used.
2 Select the required message from the "Templates" menu.
3 To edit the message, use the handset navigation key to move to different parts of
the message
, the handset key pad to add additional text, and the "Clear" soft key to
delete unwanted text
6.3.9 Write and Send a Message
A message can be constructed from scratch, or from
a predefined template that can be used
as it is or edited. The maximum message length is normally 160 characters but may be less
depending on the character set used.
The first character entered is alw
ays upper-case, followed by lower-case character. However,
this may be overriden by pressing the * -key before entering the character.
When pressing a key, the firs
t available character for that key is displayed, see 2.5
Alphanumeric Keys on
page 13. To enter the other characters supported by the key, press
the key until that character appears in the display.
The keys 0-9, * or # can be used. Keys 0 and 1 contains sp
ecial characters, see 2.5
Alphanumeric Keys on
page 13 to see all characters.
For example, to enter the character E, press key 3 twice. "E" a
ppears in the display and is
selected after a timeout or when another key is pressed.
TIP: If the system supports UTF-8 character enc
oding, the input language can be changed
temporarily by long pressing
. This can be used to temporarily access characters in a
foreign language.
To delete a character, press "Clear".
To construct and send a message, pe
rform the following steps:
1 Enter “Messaging” menu, see 3.4 Messaging on
page 17.
2 Select “Write new message”.
3 Write the message from scratch or select a message template by pressing the "More"
soft key and, if required, edit the m
essage as described in The Templates Menu on
page 37.
NOTE: The "More" key is not displayed if no m
essage templates have been defined.
4 When the message is complete, press "Send".
5 Enter the call number.
6 Press "Send" to send the message.
6.3.10 Open a Sent Message
1 Enter “Messaging” menu, see 3.4 Messaging on
page 17.
2 Select “Sent”.
3 Select message.
4 Press "View" to read the message.

ASCOM D62 Specifications

General

Brand	ASCOM
Model	D62
Category	Handsets
Language	English