ASIX Forte - Page 5

View ➙ Boot memory 49
View ➙ Configuration memory 49
View ➙ Console 49
View ➙ Display code/main memory 49
View ➙ Display data memory 49
View ➙ Display configuration memory 49
View ➙ Display programmer form 50
Device Menu 50
Device ➙ Program 50
▸ Program all 50
▸ Program all except data memory 50
▸ Program code/main memory 50
▸ Program data memory 51
▸ Program configuration memory 51
▸ Program differentially 51
▸ Differential program data memory 51
▸ Mass Production 51
Device ➙ Read 51
▸ Read all 51
▸ Read all except data memory 51
▸ Read code/main memory 51
▸ Read data memory 52
▸ Read configuration memory 52
▸ Read address 52
Device ➙ Verify 52
▸ Verify all 52
▸ Verify all except data memory 52
▸ Verify code/main memory 52
▸ Verify data memory 52
▸ Verify configuration memory 52
Device ➙ Erase 52
▸ Erase all 52
▸ Erase code/main memory 53
▸ Erase data memory 53
Device ➙ Blank check 53
▸ Blank check all 53
▸ Blank check all except data memory 53
▸ Blank check of code/main memory 53
▸ Blank check of data memory 53
▸ Blank check of configuration memory 53
Device ➙ Select device 53
Device ➙ Device info 53
Options Menu 54
Options ➙ Program settings ➙ Programming 54
▸ Reload file before every programming 54
▸ Keep manually modified data 54
▸ Warn before file load, when data in some
editor have been changed
54
▸ Warn, when the loaded file has not
changed
54
▸ Program file locations only 54
▸ Ask before erasing 54
▸ Ask before programming of OTP / Flash /
Code/Data Protection / differential
54
▸ Display fuse warning messages 55
▸ Except for programming: Close status
window
55
▸ After programming: Close status window 55
▸ Beep after successful finishing 55
▸ Beep after unsuccessful finishing 55
▸ Turn off all sound for UP 55
▸ Delay for VDD switching on/off when
supplied from programmer
55
▸ Do not perform Device ID check before
programming
55
▸ Do not perform blank check before cfg
word programming
55
▸ Do not perform blank check after erasing 56
▸ Do not erase device before programming 56
▸ Do not erase data memory before its
programming
56
▸ Do not verify unprogrammed words at the
end of the memory
56
▸ Do not verify 56
▸ Verify with two supply voltages 56
Options ➙ Program settings ➙ Panels 56
▸ Display selected device on toolbar 56