Chapter 2. Setup
NR xCell 46116A User Guide 8
Copyright © 2023, All Rights Reserved.
Red Blink (Light on for 3 seconds, light off for 3 seconds)
The small cell is overheating, please place
this device in a cool area where the
temperature is between 23~122 degrees
Fahrenheit.
We are upgrading the software in the
small cell, please wait.
Red Blink (Light on for 1 seconds, light off for 1 seconds)
1. The small cell has tried to acquire GPS
signal for 10 minutes, but failed to acquire
minimally required GPS signal. Please try
to move your GPS antenna closer to the
window.
2. If the issue persists, please call
Customer Service.
2.4 Installation
There are mainly 3 ways for NR xCell 46116A installation - wall mount, ceiling mount and pole mount.
This section will guide you through all the installation ways for NR xCell 46116A.
2.4.1 Preparation: Fix the mount base to NR xCell 46116A
No matter which mount installation method you choose, the first step is to fix the mount base to NR xCell
46116A with M4 screw*4, as shown in the figure 5.
To Next Page
Loading...