ASKEY COMPUTER CORPORATION
Chapter 3. The Askey 5G NR Small Cell Admin Website
NR xCell 46116A User Guide 34
Copyright © 2023, All Rights Reserved.
Table 13. The Askey 5G NR Small Cell Dashboard
The IP address of gNodeB. Support separately specifying the gNB local interface with AMF (N2
interface) and the UPF (N3 interface) on the gNB configuration page. The IP address is the same
value for the N2 and N3 interfaces by default.
The current state of the small cell. It will be Not In-Service or In-Service
The number of wireless devices (phone, tablets, or other data devices) currently connected to the
Askey 5G NR Small Cell
The fixed status of GNSS. It will be Searching signal or Location Acquired
The sync capability of the device
It indicates the current sync state. It should be INIT, HARD_SYNC, DISP, RESYNC, or
HOLDOVER. The cell processes will start until the sync state is DISP
Check whether the network connection status of the following server by ping command (ICMP):
AMF, EMS, KPI, and SAS
To Next Page
Loading...