The following Test Parameter Editing GPIB commands may be used to control
the memory send selection.
1=M1, 2= M2, 3=M3,
4=M4, 5=M5, 6=M6,
7=M7
The ADD command can also be used. The memory selection should be inserted
as the last parameter and should use full text as indicated on the LCD screen
such as M1 or M2.
EPM
Sets the AC1000 memory location to be used during a Line Leakage or
Functional Run test.
06 Ethernet Card
The Ethernet Card option provides RS-232 and Ethernet communication
interfaces, as well as barcode scanning capability.
The Ethernet Card has three input/output ports, shown in the following figure:
To Next Page
