the date that you want to edit. Using the numeric keypad enter the new number.
Once a parameter is edited, it is necessary to complete the edit either by pressing the
ENTER key to accept the new number or the EXIT key to escape from the edit and
return to the original number.
Set Time
From the Time and Date Setting screen highlight the Set Time parameter by using the
up or down arrow keys. Within the Set Time parameter there are three separate
fields: hours, minutes, and seconds. Use the left and right arrow keys to select the
field within the time parameter you want to edit. Use the numeric keypad to enter the
new number. Once a parameter is edited, it is necessary to complete the edit either
by pressing the ENTER key to accept the new number or the EXIT key to escape from
the edit and return to the original number.
Set Day
From the Time and Date Setting screen press the “Set Day” soft key. As the soft key
is pressed the display will toggle between the seven days of the week.
Date Format
From the Time and Date Setting screen press the “Date Format” soft key. As the soft
key is pressed the displayed date will toggle between two different date formats:
yyyy/mm/dd or mm/dd/yyyy.
Time Format
From the Time and Date Setting screen press the “Time Format” soft key. As the soft
key is pressed, the time format will toggle between 12 hour and 24 hour modes.
4.2.3. Calibration Alert
Calibration Alert is a feature that allows the instrument to give an advanced alert
before calibration for the instrument is due. From the System Setup screen press the
“Calibration Alert” soft key. The Cal. Alert Setting screen will now be displayed. From
the Cal. Alert Setting screen, three different parameters may be accessed: Cal. Due,
Alert Date, Cal. Alert. The Cal. Alert Setting screen also displays the date of the last
performed calibration. The Cal. Alert Setting screen will appear as follows:
To Next Page
Loading...
Need help?
General
