Within the Alert Date parameter are three separate fields: month, day, and year.
Using the left and right arrow keys select the field you want to edit. Using the numeric
keypad enter the new number. Once you begin typing a new number the parameter
will blank and the cursor will begin blinking. This indicates that the parameter is being
edited. Once a parameter is edited, it is necessary to complete the edit either by
pressing the ENTER key to accept the new number or the EXIT key to escape from
the edit and return to the original number.
The Calibration Alert Warning screen appears as follows:
At the Calibration Alert Warning screen there are two options: “Show this screen
again?”, and OK. “Show this screen again?” is asking if you would like to continue
seeing the Calibration Alert Warning screen every time you power up the instrument.
You may turn this screen OFF by toggling to the word “No” using the soft key next to
this parameter. If the instrument is password-protected you will need to enter the
password in order to turn off the “Show this screen again” parameter. Selecting the
“Show this screen again” parameter OFF will disable the Calibration Alert function.
Pressing the “OK” soft key will exit the Calibration Alert Warning screen and the
instrument will power up as usual.
Calibration Alert On/Off
From the Cal. Alert Setting screen you may turn the Calibration Alert function ON and
OFF by pressing the “Cal. Alert” soft key. If the “Show this screen again?” function
has been turned OFF at the Calibration Alert Warning screen this parameter will
automatically be set to OFF. Turning this parameter ON will activate the Cal. Alert
function and when the date matches the Alert Date the instrument will display the
Calibration Alert Warning screen upon power up.
To Next Page
Loading...
Need help?
General
