Asus AAEON UP Xtreme UP-WHL01 - Testing CEC-Client

CEC Client Installation 28
CEC Client Installation Supplemental Appendix for UP Xtreme
4.2.2 Testing CEC-Client
CEC-Client must be run from Terminal. Type cec-client.exe to run it. After CEC-Client
starts, it will open CEC-Client Terminal Application. From CEC-Client Terminal
Application, you can send commands for testing. Some CEC-Client commands for
testing libCEC are listed in the following table.
Command
Description
tx 10:44:41
TV change volume – volume up
on 0
Turn on TV
standby 0
Put TV in standby mode