Asus AAEON UP Xtreme UP-WHL01 - Tuner Control

CEC Client Installation 41
CEC Client Installation Supplemental Appendix for UP Xtreme
OpCode
Value
Description
Parameters
Response
Supported
<Play>
0x41
Used to
control the
playback
behavior of a
source device.
[Play
Mode]
Perform the specified
actions, or return a
<Feature Abort>
message. If media is
available the device
enters ‘Deck Active’
state. If the device is in
standby, has media
available and the
parameter is [“Play
Forward”] it should
power on.
Yes
5.1.8 Tuner Control
Command Feature: This feature allows a device (e.g. TV) to control another CEC
device’s tuner.
The following messages are used for the Tuner Control feature: <Give Tuner Device
Status>, <Record On>, <Select Analogue Service>, <Select Digital Service>, <Tuner
Step Decrement>, <Tuner Step Increment>, <Tuner Device Status>.
OpCode
Value
Description
Parameters
Response
Supported
<Give Tuner
Device
Status>
0x08
Used to request
the status of a
tuner device.
[Status
Request]
Respond with a
<Tuner Device
Status> message,
or stop reporting
changes on
receipt of
the[“Off”]
message.
Yes
<Record
On>
0x09
Attempt to
record the
specified source.
[Record
Source]
Enter ‘Recording’
state and start
recording if
possible. Send the
initiator <Record
Status>.
Yes
Table Continues on Next Page