Asus AAEON UP Xtreme UP-WHL01 - Vendor Specific Commands; OSD Display

CEC Client Installation 43
CEC Client Installation Supplemental Appendix for UP Xtreme
5.1.9 Vendor Specific Commands
Command Feature: This feature allows a set of vendor specific commands to be used
to communicate between devices.
The following messages are used for the Vendor Specific Commands feature: <Device
Vendor ID>, <Give Device Vendor ID>, <Vendor Command>, <Vendor Command
With ID>, <Vendor Remote Button Down>, <Vendor Remote Button Up>
OpCode
Value
Description
Parameters
Response
Supported
<Device
Vendor ID>
0x87
Reports the
vendor ID of this
device.
[Vendor ID]
Any other
interested device
may store the
vendor ID of the
device.
Yes
<Give
Device
Vendor ID>
0x8C
Requests the
Vendor ID from a
device.
None
<Device Vendor
ID>
Yes
<Vendor
Command>
0x89
Allows vendor
specific
commands to be
sent between two
devices.
[Vendor
Specific
Data]
Vendor Specific
Yes
<Vendor
Command
With ID>
0xA0
Allows vendor
specific
commands to be
sent between two
devices or
broadcast.
[Vendor ID]
[Vendor
Specific
data]
Vendor Specific
Yes
<Vendor
Remote
Button
Down>
0x8A
Indicates that a
remote control
button has been
depressed.
[Vendor
Specific RC
Code]
Vendor Specific
Yes
5.1.10 OSD Display
Command Feature: This feature allows a device to transfer a text string to the TV for
On Screen Display. The <Set OSD String> message is used to transfer the text string to
the TV.
The following message is used for the OSD Display feature: <Set OSD String>
Table on Next Page