Manual, F/T Sensor, Data Acquisition (DAQ) Systems
Document #9620-05-DAQ.indd-20
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 • www.ati-ia.com • Email: info@ati-ia.com
61
Figure 6.3—IFPSMC Box FT Connector Labels
Attach the New FT Label
Supplied with the Kit
12. Remove the old FT serial number label from the front panel and x the FT serial
number label supplied with the kit to the front panel for the IFPS card just installed.
Refer to Figure 6.3.
13. Connect the male connector on the transducer cable to the appropriate connector
on the front of the IFPSMC box. Note: The Serial number label on the Transducer
must match the serial number label on the IFPSMC Box connector it is plugged
into. Refer to Figure 4.9.
14. Reconnect the power supply and DAQ cables to the back of the IFPSMC box.
Refer to Figure 6.4.
15. After the procedure is complete, resume normal operation.
Figure 6.4—Power Supply and DAQ Cable Connections
Power Supply Connector
9105-C-PS-IFPSMC
IFPSMC power supply
(Included with Multi-sensor
Interface Box)
Connector 1
to DAQ Card
Connector 0
to DAQ Card
(2) DAQ Cables
(9105-C-SH6868EPM-1)
To Next Page
Loading...
Need help?
General
