Manual, F/T Sensor, Ethernet Axia
Document #9610-05-Ethernet Axia-09
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel:+1 919.772.0115 • Fax:+1 919.772.8259 • www.ati-ia.com
40
5.2 Connecting To the ATI Webpages Using a Windows Computer
To initially access the ATI Ethernet Axia F/T web pages, congure the sensor to work on the network by
assigning an IP address and provide basic information about the network.
For the initial connection, directly connect the computer to the sensor and disconnect from LAN. The
senor’s default IP address is 192.168.1.1. Temporarily change the computer’s Ethernet adapter to a static IP
address with the same rst three elds as the sensor, for example: 192.168.1.100.
NOTICE: If the computer has multiple connections to Ethernet, such as a LAN connection and a
wireless connection, select the LAN that will be connected to the Ethernet Axia sensor.
1. Disconnect the Ethernet cable from the LAN port on the computer.
2. Open the computer’s Internet Protocol (TCP IP) Properties window:
• For Windows
®
7/8/10 operating system, complete the following steps:
a. From the Start menu, select the Control Panel.
b. Click on the Network and Internet icon.
c. Click on the Network and Sharing Center icon.
d. Click on the View network status and tasks link.
e. Click on the Local Area Connection link.
f. A new window opens that displays the general settings for that local area connection link.
Click on the Properties button.
g. On the Networking tab, scroll down and select Internet Protocol Version 4 (TCP/IPv4)
connection item (refer to Figure 5.1).
h. Click on the Properties button (refer to Figure 5.1).
• For a Windows
®
Vista operating system, complete the following steps:
a. From the Start menu, select the Control Panel.
b. Click on Control Panel Home.
c. Click on the Network and Internet icon.
d. Click on the Network and Sharing Center icon.
e. Click on the Manage Network Connections task link.
f. Right-click on Local Area Connection and select the Properties button.
g. Select Internet Protocol Version 4 (TCP/IPv4) connection item (refer to Figure 5.1).
h. Click on the Properties button (refer to Figure 5.1).
To Next Page
Loading...
Need help?
General
