ATI Model F12/D Gas Transmitter Part 4 – Operation
37
O&M Manual (Rev-H)
4.5 Main Menu
Main Menu
The main menu provides direct access to the sensor calibration methods, data logger graph, and
transmitter settings.
Figure 39. Main Menu
Alarm Active Menu
When a gas or trouble alarm is active, the following menu appears in place of the main menu.
Figure 40. Alarm Active Menu
4.6 Setup Menu
Figure 41. Setup Menu.
Calibrate the gas sensor zero reading (see Sensor Zero Calibration on
page 41).
Calibrate the gas sensor sensitivity (see Sensor Span Calibration
on page 42)
View the contents of the logged data as a graph (see
Data Log Graph on page 61).
View and configure transmitter settings (below).
View the Alarm Status Menu and clear manual reset alarms. This
item appears only if a gas alarm is active (see Figure 67. Alarm Status
Menu on page 51).
View the Trouble Status Display This item appears only if the
trouble alarm is active (see Figure 71. Trouble Status Display on
pg 53).
View the Main Menu (above).
Configure sensor settings, auto-test, and calibration methods
(see
4.7 Sensor Menus, Methods, and Settings, on
next page below
Configure the three gas alarms (see
4.8 Alarm Menus, Methods, and Settings on pg 48)
View the data log graph (see 4.9 Data-log Menus, Methods, and
Settings on pg 59).
Configure the 4-20mA output, serial communications, and relay
operation (see on pg 64).
Configure the display contrast and backlighting, and panel
security (see on pg 70).
Set the real-time-clock, site name, and view version information
(see 4.12 System Menu on pg 77).
►Alarm Status
View Trouble
To Next Page
Loading...
Need help?
General