D41 7
1.1 Starting the paver finisher
Before starting the paver finisher
Before starting the diesel engine and beginning operation, the following steps must
be performed:
- Daily maintenance of the paver finisher (see chapter F).
Check the operating hours counter to determine whether further maintenance work
should be conducted.
- Check the safety devices and protective devices.
"Normal" starting
- Set the drive lever (6) to the centre position and the travel drive preselector (10)
to minimum
- Insert the ignition key (11) in position "0".
The lights should be switched off during starting to reduce the current drain on the
battery
It is impossible to start the vehicle, if one of the emergency stop buttons (16)/(120)
is depressed.
- Switch the ignition key to start the engine. Do not let the starter run permanently
for more than 20 seconds; allow for a break of 1 minute after every attempt!
To Next Page
Loading...
Need help?
General
