D41 27
Screed charging/relieving
This function charges or relieves the screed regardless of its own dead weight.
Function (26): Relieving/Charging (Switch down“heavier”,Switch up “lighter”).
The "Screed charging and relieving" functions are only effective when the paver
finisher moves. According to the activated function, the paver finisher is
automatically switched to "paving stop + relief" when stationary.
Screed control with paver finisher stop/in paving operation
(screed stop / paving stop / floating paving)
Button (23) can be used to activate the following functions:
- Screed stop / floating position
- Screed is hydraulically held in position.
Function for setting up the paver finisher and for lifting/lowering the screed
- Paving stop / floating paving
The following function is active depending on operating status:
- "Floating paving": during paving operation.
Lower screed to the floating position with preselected screed charging/relieving
function.
Adjusting the pressure
Pressure adjustments can only be made while the diesel engine is running.
Therefore:
- Start the diesel engine and turn the traction controller(5) back to zero (precaution
against inadvertent advancing).
- Activate the "floating position" using switch (23)
To Next Page
Loading...
Need help?
General
