D41 31
1.7 Interrupting/terminating operation
During breaks (e.g. the material supply truck is late)
- Determine the approximate duration.
- When cooling down of the material below the minimum paving temperature must
be expected, run the paver finisher empty and create an edge like the end of a
layer.
- Set the drive lever (6) to the centre position.
During longer breaks (e.g. lunch break)
- Drive lever (6) into centre position, RPM speed adjustment (5) to minimum
position.
- Switch off the ignition switch.
- Switch the screed heater system off.
- With a screed with gas heating system (O), close the bottle valves.
Long-time parking on a slope transversally is prohibited!
The screed must be heated up to the correct paving temperature before paving
may be restarted.
To Next Page
Loading...
