F60 5
High-pressure filter
The filter elements must be replaced when the maintenance indicator (A) turns
red.
The vehicle's hydraulic system contains 1
high-pressure filter.
- Unscrew filter housing (B).
- Remove the filter cartridge.
- Clean the filter housing.
- Insert the new filter cartridge.
- Replace the seal ring of the filter housing.
- Turn on the filter housing by hand and
tighten it using a wrench.
- Start trial operation and check the tightness of the filter.
Replace the seal ring whenever the filter cartridge is replaced.
After replacing the filter element, the red mark in the maintenance indicator (A)
automatically reverts to green.
To Next Page
Loading...
