C11 4
2.2
Driving onto the low-bed trailer
Make sure that there are no persons in the danger area during loading.
- Use the work gear and low travelling speed to drive onto the low-bed trailer.
- Lower the screed onto wooden blocks on the low-bed trailer.
- Switch off the paver finisher.
- Attach and secure the protective hood to shield the operating panel.
- Lower the protective roof when necessary(O):
See section entitled āProtective roofā
2.3
Secure the paver finisher to the low-bed trailer
- Use only appropriate, approved attachment devices.
- Use the four securing points (1,2,3,4) provided on both sides of the vehicle.
For a paver finisher without roof:
- Wait until the exhaust extension pipe has cooled down; then remove it and store
properly.
Always observe the local regulations on securing loads!
To Next Page
Loading...
