F60 8
Pump distribution gear
- Oil level check on dipstick
(A).
- The oil level must lie
between the upper and
lower remarks.
For filling in the oil:
- Pull out the dipstick (A) completely.
- Add new oil through the oil level gauge hole opening.
- Check the fluid level using the dipstick.
Before checking with the dipstick, wait for a moment, as the oil which has been
poured in first has to flow off.
Make sure to clean the screw and the vicinityof the drain bore!
Oil change:
- Drain gear oil through oil
drain plug (B) at bottom of
distributor gear.
- Collect gear oil by using
corresponding container.
- Change new seal rings
when reinstalling plug.
- Fill oil through the dipstick
opening (A).
- Check fluid level using the
dipstick.
The oil should be changed when at operating temperature.
To Next Page
Loading...
