Atlas Copco Dynapac F3030C User Manual

F40 10
Auger blade (8)
If the surface of the auger blade (A)
becomes sharp-edged, the diameter of
the auger is reduced and the blades (B)
have to be replaced.
- Remove the bolts (C), washers (D),
nuts (E) and auger blade (B).
Risk of injury due to sharp-edged parts!
Auger blades must be installed play-free;
the contact surfaces must be dirt-free!
- Install the new auger blades (B);
replace the bolts (C), washers (D) and
nuts (E) if necessary.

Atlas Copco Dynapac F3030C Specifications

General

Brand	Atlas Copco
Model	Dynapac F3030C
Category	Construction Equipment
Language	English