F50 5
Changing the oil filter
The oil filter is accessed via the service flap (E)
on the vehicle’s center wall.
- Remove the bolts (F) , pull the service flap
(E) out.
- After completing the maintenance work,
reinstall the service flap (E).
The new filter is inserted during an oil change
once the used oil has been drained out.
- Loosen the filter (G). Clean the contact
surface.
- Apply light coating of oil to the gasket on
the new filter and fill filter with lube oil
before installing it.
- Tighten filter by hand.
After installing the oil filter, attention must be paid to the oil pressure display and
good sealing during the test run. Check oil level again.
To Next Page
Loading...
Need help?
General
