F100 3
2. General inspection
The daily routine should comprise a visual inspection around the entire paver
finisher. The following items must be checked :
- Are components or controls damaged ?
- Are there leaks on the engine, the hydraulics, the gearbox, etc.?
- Are all fastening points (conveyor, auger, screed, etc.) in order ?
Immediately take actions to correct any detected malfunction to avoid damages,
dangers or environmental hazards!
3. Inspection by an expert
Have finisher, screed and optional gas or electric system checked by a trained
specialist.
- When required (according to the operating conditions and the nature of
application),
- However, at least once a year, check that they are all in good operational
condition.
To Next Page
Loading...
