Atlas Copco Dynapac F3030C User Manual

B 18
1
Decal "Drive system brake release-instructions"
2
Label "Diesel drainage point"
3
Warning plate "Hot surface!"
4
Prohibition lable "Forbidden to open the cover when engine running! "
5
Label "Wear ear protectors"
6
Label "Operating instructions"
7
Lable "Spraying with water prohibited"
8
Label "Forbidden to climb"
9
Label "Swivel seat in/out"
10
Label "Fixing points for crane transportation"
11
Label "Lift point"
12
Label "Risk of hand injuries"
13
Label "DYNAPAC"
14
Paver finisher identification plate
15
Rivet
16
Label "Hydraulic oil "
17
Label "Health hazard, environmental hazard"
18
Label "Machine type"
19
Warning plate "Risk of crushing!"
20
Label "Radiator" - Forbidden to mix
21
Warning plate "Danger from fan! "
22
Warning plate "Warning on dangers posed by batteries"
23
Label "Drainage point of hydraulic tank"
24
Label "Operating instructions"
25
Label "Electrical system - danger of high voltage"
- Disconnnect batteries and electronics during welding work or when
changing the batteries, or use a service watchdog in accordance with
the instruction manual.
26
Label "Screed lock"
- Only charge or work under the screed when this is secured with the
screed lock. Danger of accidents!
- With mechanical screed lock: insert only at crown adjustment “zero”.
- Screed lock only for transportation purposes.
27
Label "Notes on engine start"
- Adjust the engine speed appropriately and let the engine reach
operating temperature for 5 minutes at half speed after cold-starting.
- At the end of work, allow the engine to idle for at least 5 minutes. Remove
the ignition key after switching off the engine.
28
Label "Main battery switch"
29
Label " Engine oil "
30
Label " Diesel oil "
31
Label "Atlas Copco"

Atlas Copco Dynapac F3030C Specifications

General

Brand	Atlas Copco
Model	Dynapac F3030C
Category	Construction Equipment
Language	English