6
2. 1 Height adjustment...........................................................................................2
Grain sizes up to 16mm..............................................................................2
Grain sizes > 16 mm...................................................................................2
2. 2 Mechanical adjustment with ratchet................................................................3
2. 3 Hydraulic adjustment.......................................................................................3
2. 4 Height adjustment for large working widths / with brace..................................4
3 Auger extension...............................................................................................5
3. 1 Mounting the auger shaft extension and chute plate.......................................6
3. 2 Auger extension chart......................................................................................8
Working width 2520mm...............................................................................9
Working width 3094mm.............................................................................10
Working width 3734mm.............................................................................11
Working width 4983mm.............................................................................12
Working width 5557mm.............................................................................13
Working width 6197mm.............................................................................14
Working width 7446mm.............................................................................15
Working width 8020mm.............................................................................16
Working width 8660mm.............................................................................17
3. 3 Mounting the auger brace (pull rod) .............................................................18
3. 4 Aligning the auger ………..............................................................................20
4. Offsetting the screed.....................................................................................21
5. Levelling.......................................................................................................22
5. 1 Slope controller.............................................................................................22
5. 2 Mounting the sensor arm...............................................................................23
5. 3 Mounting the grade control system................................................................23
5. 4 Setting up the sensor arm..............................................................................24
5. 5 Big ski 9 m, big ski 13 m................................................................................25
Mounting the big ski bracket on the crossbeam........................................27
Mounting the swivel arms..........................................................................28
Mounting the centre element.....................................................................29
Extending the big ski.................................................................................30
Mounting the sensor bracket.....................................................................31
Mounting and aligning the sensors............................................................32
Mounting the distributor box......................................................................33
To Next Page
Loading...
