Preparation before Use
21
PREPARATION
(2) Be sure that the rubber feet of the incubator are
placed on the incubator retainer before tightening
the lever of the retainer to secure the incubator.
Lever
Incubator
retainer
3-2.
Adjusting the HL Stand
The HL stand is steplessly adjustable in height in a range from 48 to 80cm (from the bottom of the incubator
to the floor). Perform the following procedures to adjust the height of the stand.
(1) Make sure that the stand is secured using the re-
tainer.
(2) Grasp the top frame with both hands and raise the
operating lever up to unlock the lever. Raise the
stand to the desired height.
(3) To lock the stand, release the operating lever.
z
The stand has a damper to assist with raising and
lowering. For safety, two persons must raise or
lower the stand with an incubator in position.
To unlock
Upper frame
Operating lever
3-3.
Where to Install the Incubator
Avoid installing the incubator in direct sunlight, near a stove or a radiator, in the direct airflow of
an air conditioner, or by a cold window in order to prevent it from being directly affected by
such external thermal conditions.
Do not place the unit where it can disturb the operation of power plug.
Install the incubator on a level surface in a location where it is easy to operate except when being transport-
ed. Avoid installing it near a heating apparatus, beside a window, or where fire is used.
To Next Page
Loading...