Safety Instructions
14
The unit should only be serviced by qualified personnel in accordance with the appropriate
service manual.
Be sure to inspect the unit at the start of each day.
Operating the unit without inspecting it at the start of each day may result in a defect passing unnoticed and
cause a potentially unfavorable outcome.
If the unit fails to operate correctly, stop using it immediately.
Indicate on the incubator that it is out of order and contact your local Atom representative.
Do not reuse the disposable safety bands.
Change the disposable safety bands for every infant. Reusing them could lead to infection.
Do not stare into the lighting lamp or expose your eyes to the light.
Doing so may cause retinal damage.
1-3.
CAUTION
Injury or damage to surrounding objects may result if the instructions given below are not followed.
Place the infant in the incubator only after the incubator air temperature has stabilized.
Prior to placing the infant in the incubator, pre-warm the incubator to keep the incubator air temperature stable.
Do not forcefully pull on or twist cords.
When feeding the cords and tubes into the unit, be very careful not to let them wind or
tighten around the infant.
Do not press strongly or rub on the LCD screen.
Doing so may result in damage or malfunction.
Do not allow any chemicals to adhere to the display.
If any chemicals do adhere to the display, wipe them off immediately.
Check that the peripheral devices operate correctly.
A device that transmits or receives faint signals may be affected by the electromagnetic waves generated by the
unit. If such a device is used in the vicinity of the unit, check the operation of that device for any detrimental ef-
fects before using the unit in clinical environments. Stop using the unit immediately if any problems occur.
Unplug the power plug before moving the unit to another location or when the unit is not
used for an extended period of time.
Moving the unit to another location with the power plug connected to a power outlet will damage the power cord
and may cause a fire or electric shock.
Do not apply impact to the unit or hit it on something.
Doing so may result in damage or malfunction.
To Next Page
Loading...
