PLEASE READ WITHOUT FAIL
Safety Instructions
13
If a fire should occur, extinguish it using a fire extinguisher for an electrical fire (Class C
fire), notify the fire department, and contact our sales representative immediately.
z
Remove the power cord to stop the power supply.
z
Keep the battery away from objects that may cause a secondary fire, such as cylinders and flammables.
Stop using the battery if problems such as damage or deterioration are found, and discard
the battery as described below:
z
In the case of medical institutions: Immediately request a specialized contractor to dispose of the batteries as
medical waste.
z
In the case of a company or public institution: Dispose of it as industrial waste.
z
In other cases such as where the unit belongs to an individual: Dispose of the battery according to the in-
struction of your local government.
If you are not sure how to dispose of the battery, contact your local Atom representative.
Charge the battery as instructed.
Failure to do so may cause the battery to leak, generate heat or smoke, rupture, or ignite.
If the battery is not fully charged after the specified charging time period has elapsed, stop
charging it.
Failure to do so may cause the battery to leak, generate heat or smoke, rupture, or ignite.
Do not charge the battery in locations such as gas stations where flammable gases (pro-
pane gas, gasoline, etc.) or fine particulates are produced.
Otherwise, gases may ignite.
Doing so may cause an explosion or fire.
If a leakage is suspected or you detect a strange odor, keep the battery away from fire.
Failure to do so may cause the battery to leak, generate heat or smoke, rupture, or ignite.
Do not directly touch electrolyte that has leaked from the battery cover.
If any electrolyte comes in contact with your eyes, you may lose your sight. If it comes in contact with your skin
or clothing, it may cause irritation. Flush it immediately with plenty of water and consult a physician.
Install the unit on a stable surface.
Installing it on an unstable surface or a slope may cause it to topple, fall, or move, resulting in injury or damage.
Therefore, before installing the unit, make sure that the place where the unit is to be installed is stable and
strong enough to support the weight of the unit.
Do not subject the oxygen sensor to impact.
If the oxygen sensor is damaged, the electrolyte inside may leak out of the sensor. If contact with the skin or
clothing occurs, rinse the area immediately with running water.
Do not touch the heaters during use or shortly after use.
The heaters are very hot during use and shortly after use. Allow the heaters to cool down sufficiently before
cleaning and disinfecting them in order to avoid injury.
Do not attempt to disassemble or modify the unit.
A fire, electric shock or injury may result.
To Next Page
Loading...
