Power requirements
26
J
How to Replace the 4A Fuse (for AC Power)
If an overcurrent condition occurs during use, the fuse blows out to interrupt the power supply in order to
prevent accidents. Follow the steps below to replace the blown fuse.
(1) Press the
switch to turn the power off.
(2) Disconnect the power cord from the AC inlet.
(3) Insert the tip of a flat blade screwdriver into the
slot in the top of the fuse box. Push the screw-
driver to pull the fuse box out.
Fuse
Fuse box
(4) Remove the old fuse and replace it with a new one.
(5) Push the fuse box back into place.
(6) Reconnect the power cord to the AC inlet.
z
If the replaced fuse blows out again, stop using
the incubator and contact your local Atom repre-
sentative.
To Next Page
Loading...
