Maintenance and Inspection
84
(2) Pull out the oxygen sensor module from the hood.
Oxygen sensor module
(3) Remove the sensor holder by turning the holder
retaining ring in the direction of the arrow shown
in the illustration on the right. Then, remove the
oxygen sensor.
Holder retaining ring
(4) Fit the new oxygen sensor to the connector of the
oxygen sensor cover.
Connector
(5) Align the protrusion of the oxygen sensor cover
with the notch in the sensor holder. Then, turn the
holder retaining ring in the direction of the arrow
shown in the illustration on the right to fit the sen-
sor to the holder.
Notch in sensor
holder
Protrusion of oxygen
sensor cover
(6) Put the oxygen sensor module into the oxygen sen-
sor inlet on the hood and connect the cable con-
nector to the oxygen sensor connection port on the
left side of the main body.
Oxygen sensor module
Oxygen sensor inlet
To Next Page
Loading...
