STANDARD FACTORY SETTINGS
Input Mute: All Off
Phantom Power: All Off
Input Gain: -12 dB
ALC: All disabled
Mono / Stereo: Stereo
Output Mute: All Off
Single ended: All Off
Anti-Phase: All Off
Delay: 0 ms
Maximum volume: 0 dB
Talkover: Disabled
Three band equalizer: All enabled
Q-factor: 0.4
Center frequency: 90 Hz / 1.2 kHz / 12.5 kHz
Level: 0 dB
Seven band equalizer: All Disabled
Q-factor: 0.9
Center frequency: 55 Hz / 150 Hz / 400 Hz / 1050 Hz / 2.6 kHz / 6.5 kHz / 16 kHz
Level: 0 dB
Filters: All Disabled
Low-pass Frequency: 10 Hz
High-pass Frequency: 20 kHz
Direct output names: ‘Output 1’ to ‘Output 8’
Wall panel output names: ‘WP Out 1’ to ‘WP Out 8’
Fiber output names: ‘FB Out 1’ to ‘FB Out 8’
Direct input names: ‘Input 1’ to ‘Input 8’
Wall panel input names: ‘WP In 1’ to ‘WP In 8’
Fiber input names: ‘FB In 1’ to ‘FB In 8’
Scene names: ‘Scene 1’ to ‘Scene 8’
Global scene names: ‘Global scene 1’ to ‘Global scene 8’
Timer settings: no actions configured
Paging Volume: -0 dB / Switch Relay disabled
Fiber Settings: ‘Pass through’
Amplifier bridging: All Disabled
M2 Factory settings
To Next Page
Loading...