AUDAC M2 - Voice File

48
Settings >> Voice File
InthiswindowthesettingsfortheinternalvoicefileinterfaceoftheM2canbemade.
Upto16differentvoicefileconfigurationscanbemadeandthemessageshouldcomply
tofollowingrequirements:*.wavaudiofileformat,16bitstereo,48kHzsamplingrate,
filenameshouldnotexceed8characters+extension(*.wav).
ThemessagesshallbestoredonanSDmemorycard(SDHCalsosupported)whichshall
bepluggedininsidethememorycardslotonthefrontsideoftheM2.Themessages
shallbestoredina‘...\Messages\’folder.Thememorycardshallremainpluggedinwhile
operatingthesystem.
FILETYPE & STORAGE REQUIREMENTS
Filetype: *.wav
Bitrate: 16 bit Stereo
Sampling rate: 48 kHz
Filename: Max 8 Characters + extension (*.wav)
Storage medium: SD Card (SDHC Compatible)
Storage folder: Stored in ‘...\Messages\’ folder.
Filesystem: FAT32
M2 Voice File Presets
Thetopsideofthiswindowshowsdifferenttabsgoingfrom1to16.Eachofthesetabs
representsapresetforavoicefileannouncements.Simplyswitchtothedesiredtabby
clickingitsnumber.

Fourdropdownlistsareshownontheleftsideofthewindow.Allfileswhicharestoredon
theinsertedSDcardareshowninthe‘File’dropdownlist.Thefilewhichshallbeplayed
upontriggeringthepresetcanbeselectedinthislist.Makesuretheselectedfilehasa
*.wavextensionanditcompliestothefilerequirementsasdescribedabove.
