Audi TT Coupe 2016 - Adjusting the Magentic Zone; Calibrating the Compass

.....
N
G:
CX)
.....
"'
U"I
.....
"'
.....
"'To turn the compass on or off, pr ess the button
@ until the compass in the mirror appears or
disappears.
The digital
compass only works when the ignition
is turned on. T he directions are indicated with ab -
breviations:
N (north), NE (northeast), E (east),
SE (southeast), S (south), SW (southwest), W
(west), NW (northwest).
@ Tips
To prevent inaccurate compass readings, do
not bring any remote controls, el ectr i cal devi-
ces
or metallic objects near t he mirror.
Adjusting the magnetic zone
Applies to: vehicl es with digital compass
®
Fig. 41 North America: m ag netic zone map
"' Press and hold the button @ ¢ page 42, fig . 40
until the number of the magnetic field zone ap-
pears in the rearview m ir ror.
"' Press the button @ repeatedly to select the
correct magnetic zone. The select ion mode
turns off after a few seconds .
Lights and V i sion
Calibrating the compass
Applies to: vehicles with digital compass
If the display is in cor r ect or inaccurate, the com-
pass must be recalibrated.
"' Press and hold the button @ until a C appears
in the rearview mirror.
"' Drive in a circle at about 5 mph (10 km/h) until
a direction
is displayed in the rearvi ew mi rror.
WARNING
- To avoid endangering yourself and other
drivers, calibrate the compass in an area
where there is no traffic.
- Always pay
attention to the traffic and the
area around your vehicle if you are reading
the compass while driving.
43