Audio Precision ATS-1 Access User Manual

Measurements may be displayed in a wide variety of units, including
the following:
.
volts
.
dBm (with a user-specified impedance reference)
.
dBu
.
dBV
.
dBr (dB relative to a stored measured value)
.
dBg (dB relative to the present generator output amplitude)
.
watts (with a user-specified impedance reference)
.
Hz/kHz
.
% or dB for relative measurements
The chosen units are remembered for each measurement function, so
when you return to that function the units will be automatically
displayed.
Several band-limiting and noise-weighting filters are provided:
.
Standard 22 Hz-22 kHz audio bandpass
.
30 kHz and 80 kHz lowpass
.
400 Hz highpass
.
Tunable 1/3 octave bandpass
.
A-weighting (IEC-A)
.
CCIR weighting
.
Sockets for two optional filters, selectable from a wide variety
The selected filter for each measurement function is remembered, so
that next time you use that function the same filter will be selected.
Signals within the audible range can be monitored using the built-in
loudspeaker or with user-supplied headphones. An external volume
control is provided.
Up to 30 complete panel setups can be stored in internal memory so
that common test setups can be easily recalled. This memory persists
even when the unit is unplugged. In addition, test setups can be stored
& For information
on filter shapes, see
page 1-6.
1 Description
Introducing the ATS-1 Access Description
1-4 ATS-1 Access User's Manual

Audio Precision ATS-1 Access Specifications

General

Brand	Audio Precision
Model	ATS-1 Access
Category	Test Equipment
Language	English